特性: PROFIBUS DP slave 界面 enables Siemens PLCs or a similar host supporting the PROFIBUS DP protocol to exchange data with other protocols.
分类: Stand-alone Gateway
应用 Ports: Modbus Plus Connector
Two DB9 Female Standard Modbus Plus Connectors
Ethernet Port (Ethernet modules only): 10Base-T half duplex RJ45 Connector
Link and Activity LED indicators
Electrical Isolation 1500 V RMS at 50 Hz to 60 Hz for 60 s, applied as
specified in section 5.3.2 of IEC 60950: 1991
Ethernet Broadcast Storm Resiliency = less than or equal to 5000 [ARP] frames-
per-second and less than or equal to 5 minutes duration
LED Indicators: Power and Module Status
应用 Status
Serial Port Activity
Serial Port Error Status
Dimensions: Standard:
5.20 in H x 2.07 in W x 4.52 in D (13.2 cm x 5.25 cm x 11.48 cm)
Extended:
5.20 in H x 2.73 in W x 4.52 in D
(13.2 cm x 6.934 cm x 11.48 cm)
Relative Humidity: 5% to 95% (with no condensation )
电源: 24 VDC nominal
18 to 32 VDC allowed
Positive, Negative, GND Terminals
2.5 mm screwdriver blade
Port: 2
界面: RS-232, RS-422, RS-485
Ethernet: 10Base-T
Standard: ATEX, CE/EMC, Environmental, UL,GOST-R
Storage Temperature: -40° F to 185° F (-40° C to 85° C)
运行温度: -4° F to 122° F (-20° C to 50° C)
Current Load: 500 mA max @ 32 VDC max
商标名称: PROSOFT
子品牌: 5000
周围条件: -20 to 50DEG C Operating, -40 to 85DEG C Storage, 5 to 95 Percent Humidity
应用: Manufacturing, Oil and Gas, Electrical Power and Food Processing.
Configuration Serial Port: DB-9M RS-232 only
No hardware handshaking
Serial Port Isolation: 2500 V RMS port signal isolation per UL 1577
3000 VDC min. port to ground and port to logic power isolation
Shipped with Each Unit: Mini-DIN to DB-9M serial cables
4 ft RS-232 configuration cable
2.5mm screwdriver
CD (docs and Configuration utility)
RS-422/485 DB-9 to Screw Terminal Adaptor (1 or 4, depending on ports)
Data Transfer Rate: 110 to 115
Configuration: Yes
Frequency Rating: 50 to 60
Connectivity: Serial
Protocol: PDPS, MCM
Software Requirements: Drivers
Enclosure: Aluminum
Length: 4.52
Width: 2.07
Height: 5.2
ProLinx DNP從站到PROFIBUS DP從站網關可在DNP和PROFIBUS主站設備之間建立強大的連接。這個獨立的DINrail安裝協議網關提供一個串行端口和一個PROFIBUS從站端口。
