Shipped with Each Unit: Mini-DIN to DB-9M serial cables
4 ft RS-232 configuration cable
2.5mm screwdriver
CD (docs and Configuration utility)
RS-422/485 DB-9 to Screw Terminal Adaptor (1 or 4, depending on ports)
Serial Port Isolation: 2500 V RMS port signal isolation per UL 1577
3000 VDC min. port to ground and port to logic power isolation
应用 Ports: Modbus Plus Connector
Two DB9 Female Standard Modbus Plus Connectors
Ethernet Port (Ethernet modules only): 10Base-T half duplex RJ45 Connector
Link and Activity LED indicators
Electrical Isolation 1500 V RMS at 50 Hz to 60 Hz for 60 s, applied as
specified in section 5.3.2 of IEC 60950: 1991
Ethernet Broadcast Storm Resiliency = less than or equal to 5000 [ARP] frames-
per-second and less than or equal to 5 minutes duration
Configuration Serial Port: DB-9M RS-232 only
No hardware handshaking
LED Indicators: Power and Module Status
应用 Status
Serial Port Activity
Serial Port Error Status
Dimensions: Standard:
5.20 in H x 2.07 in W x 4.52 in D (13.2 cm x 5.25 cm x 11.48 cm)
Extended:
5.20 in H x 2.73 in W x 4.52 in D
(13.2 cm x 6.934 cm x 11.48 cm)
Relative Humidity: 5% to 95% (with no condensation )
Storage Temperature: -40° F to 185° F (-40° C to 85° C)
运行温度: -4° F to 122° F (-20° C to 50° C)
Current Load: 500 mA max @ 32 VDC max
电源: 24 VDC nominal
18 to 32 VDC allowed
Positive, Negative, GND Terminals
2.5 mm screwdriver blade
周围条件: -20 to 50DEG C Operating, -40 to 85DEG C Storage, 5 to 95 Percent Humidity
Height: 5.2
Width: 2.07
Length: 4.52
Enclosure: Aluminum
Software Requirements: Drivers
Protocol: DH485, DNP 3.0
Connectivity: Serial
Frequency Rating: 50 to 60
Configuration: Yes
Data Transfer Rate: 110 to 115
Port: 3
界面: RS-232, RS-422, RS-485
Ethernet: 10Base-T
Standard: ATEX, CE/EMC, Environmental, UL,GOST-R
应用: Manufacturing, Oil and Gas, Electrical Power and Food Processing.
特性: Ideal solution for applications where DNP Master connectivity can be used to integrate Modbus devices into a system; The DNP gateway is a powerful module designed with both Server support, enabling easy connection to Rockwell Automation PLCs (CLX, SLC, PLC, CPLX, and similar devices).
分类: Stand-alone Gateway
子品牌: 5000
商标名称: PROSOFT
The ProLinx DNP 3.0 Master to Modbus Master/Slave Gateway creates a powerful connection between devices on a DNP network and Modbus devices. This stand-alone DIN-rail mounted protocol gateway provides up to four serial ports. The DNP 3.0 Master protocol driver supports Master implementations of the protocol on one port. This port is fully configurable. The Modbus protocol driver supports Master and Slave implementations of the protocol. All Modbus serial ports are individually configurable, providing a very powerful and flexible host or device interface solution.
